Hi Nick,
Thanks for confirming that ... its been a bug for me since day1, over 12
months.
For some reason xailer support is not responding to this thread.
Regards
Chris
"Nick Hilder" <nick_n0_spam_atcapsol.com.au> wrote in message
news:[email=
48602097@ozsrv2.ozlan.local...]
48602097@ozsrv2.ozlan.local...[/email]
> Ok, yes, I can confirm this is a bug, it's only a bug at design time. When
> you reopen the project the browse is on the wrong tab. Once you click the
> tab control it is fixed. Until you reopen the editor
>
> Nick
>
>
> "Nick Hilder" <nick_n0_spam_atcapsol.com.au> wrote in message
> news:[email=
4860186f@ozsrv2.ozlan.local...]
4860186f@ozsrv2.ozlan.local...[/email]
>> Hi Chris
>>
>> Have you tried reordering the controls in the object inspector using the
>> arrows
>>
>> I find sometimes you put a control down, say a status bar and it doesn't
>> appear. You reorder the controls , close the project and reopen, and
>> bingo, it's all fixed. Took me ages to work this out, frustrated the hell
>> out of me.
>>
>> It seems to be especially important when you are docking things.
>>
>> Nick
>> "Chris Gillard" <
chris@bluesquare.co.uk> wrote in message
>> news:[email=
485a6a08@ozsrv2.ozlan.local...]
485a6a08@ozsrv2.ozlan.local...[/email]
>>> Any comment ??
>>>
>>> Chris
>>>
>>> "Chris Gillard" <
chris@bluesquare.co.uk> wrote in message
>>> news:48526969$[email=
1@ozsrv2.ozlan.local...]
1@ozsrv2.ozlan.local...[/email]
>>>> There is a problem with the display of tab Control pages the FIRST TIME
>>>> you open a form in the IDE.
>>>>
>>>> If the page appears with focus say on tab #3, you will see the contents
>>>> of page #1.
>>>>
>>>> Once you click on the tabs it works properly.
>>>>
>>>> I have observed this for many months.
>>>>
>>>> This appears to be easily repeatable including in 1.9.4
>>>>
>>>> Regards
>>>>
>>>> Chris
>>>>
>>>>
>>>>
>>>
>>>
>>
>>
>
>