Xailer & OZ Software

Hallo
I got a GPF when opening a certain project.
The xpj was working before. The project has more than 100 files and it may be that I changed/removed a file from disk.
But hard to find out which one...
I also encounter GPF when trying to add more than 15-20 files at the same time. Adding files in groups<10 works fine.
But it is a bit annoying that the editor always opens all added files by default!
However, there should not be a GPF on loading non-existing files.
I attached the error.log as hivetec-error.log and would appreciate a solution.
Harry Bleckert
hivetec UG
http://hivetec.net

Harry escribió el mié, 06 junio 2012 06:45Hallo
I got a GPF when opening a certain project.
The xpj was working before. The project has more than 100 files and it may be that I changed/removed a file from disk.
But hard to find out which one...
I also encounter GPF when trying to add more than 15-20 files at the same time. Adding files in groups<10 works fine.
But it is a bit annoying that the editor always opens all added files by default!
However, there should not be a GPF on loading non-existing files.
I attached the error.log as hivetec-error.log and would appreciate a solution.
Harry Bleckert
hivetec UG

Try to disable completely Intellisense: manual mode, no automatic synchronicity and do not include project files and reload the project.
After that, try to close all the project files, set the Intellisense and open the files one by one, to see which one is causing the error. (I guess it maybe an empty but existing file)
Regards,

Hola Ignacio
Thx. That worked. Intellisense settings active caused the GPF on project load.
Would be great though if that bug could be traced and eliminated.
Harry
hivetec UG
http://hivetec.net

Harry escribió el vie, 08 junio 2012 04:16Hola Ignacio
Thx. That worked. Intellisense settings active caused the GPF on project load.
Would be great though if that bug could be traced and eliminated.
Harry
hivetec UG
http://hivetec.net
I will highly appreciate your help on that
That is why I told you to reset Intellisense and then include the files one by one until you get the problematic file. Afterwards, if you dont mind, you could send us that file, so we can fix it.
TIA
Regards,